Vibration Sensor
The AKCP vibration sensor is a normally closed input switch that will detect when there is vibration, or a window is broken. It can be connected to both the sensorProbe or securityProbe base units and then linked to notification alerts.
This sensor is designed for protecting against forced entry by hammer, saw, crowbar etc… through walls, ceilings, windows, safes, cabinets, etc… It will initiate an alarm when a vibration from a non-desirable force strikes the protected surface. A built-in tamper switch is independent from the circuit of the vibration detector for your convenience.
Connection Flexibility
The vibrationDetect sensor can be connected to the sensorProbe and securityProbe units via the RJ-45 dry contact sensors. Or it can be directly connected to the dry contact inputs on the sensorProbe8-X20, sensorProbe8-X60, securityProbeX-20 and securityProbe-X60 units allowing security protection for many windows using only a single base unit.
| Measurement Range | Alarm or Normal |
| Sensor Type | Normally Closed contact input switch |
| Contact Pressure | Adjustable from 1 to 50 grams but recommended setting between 5 and 25 grams only. Supplied with pressure of approximately 6 grams. |
| Contact Break Time | Approximately 45ms maximum (at 6-grams of pressure) |
| Rated | 1A at 50VDC |
| Life | Over 100,000 contacts |
| Contacts | Pure silver |
| Case | ABS resin. |
| Interface | |
| Communications Cable | RJ-45 jack to sensor using UTP Cat 5 wire |
| Communications Cable Max. length | 1000 Ft (305m) with approved low capacitance shielded cable or UTP |
| Power Source | Powered by the controller unit. No additional power needed |
| Full autosense including disconnect alarm | |
| Dimensions | 15mm(H) x 21mm(W) x 60mm(L) |
| Weight | 20 grams. |
| Sensor count | 1 |
