Siren and Strobe Light
The combined strobe light and siren can add eye-catching audio visual alarms to the sensorProbe and securityProbe series base units. When triggered, the siren generates a loud alarm accompanied with a bright flashing strobe light, giving a clear alert of an alarm condition.
Powered by the base unit, with no additional power required, it’s perfectly suited for use in mission critical situations. The siren and strobe can be triggered by another sensors status, or controlled manually via the web interface or using it’s own SNMP OID.
- Combined siren and strobe on a single Intelligent sensor port
- Powered by the base unit, no additional power source required
- Can be extended up to 30 m (100 ft.) from the base unit
- 100db Siren sound
- 400x per minute flashing strobe
| Light Source | Super bright LEDs x8 400 flash Times/Minute |
| Sound | 100dB ±3dB@100cm |
| Sensor Type | High / Low Output Switch |
| Control | ON or OFF |
| Optional | Manual Sound and Light variator |
| Operating Temperature | -40°C to 70°C |
| Storage Temperature | -40°C to 70°C |
| Interface | |
| Communications cable | RJ-45 jack to sensor using UTP CAT5e/6 cable |
| Power source | Powered by the controller unit. No additional power needed |
| Power Consumption | Typical 550 mWatt, 110mA |
| Maximum Cable Length | The Siren and Strobe Light can be extended from the RJ-45 Intelligent Sensor ports on the base units up to 100 feet, or 30 meters using standard CAT5/6 LAN cable |
| Dimensions | 123 x 72 x 45 mm |
| Sensor count | 1 |
